Now when everyone is decorating, many parents need to use the freezer pipe bender. But you may not know how to use the freezer pipe bender. The following editor will introduce some methods of using the freezer pipe bender. Those who need to use the freezer pipe bender, but do not know how to use the freezer pipe bender, please follow the editor to see the introduction of the freezer pipe bender.
Freezer pipe bender
Freezer pipe bender use-conventional pipe bending operation
1. Hold the forming handle of the pipe bender or fix the pipe bender on a vise.
2. Loosen the hook and raise the slider handle.
3. Place the pipe in the groove of the forming disc and fix it in the forming disc with a hook.
4. Lower the slider handle until the "0" scale line on the hook is aligned with the 0° position on the forming plate.
5. Rotate the slider handle around the forming disc until the "0" scale line on the slider is aligned with the required degree on the forming disc.
Freezer pipe bender use-90° to 180° bending
Follow steps 1-5 above for a 90° bend.
1. After the pipe has been bent to 90°, rotate the slider handle to unlock the X-Tune steering mechanism.
2. Lift the slider handle around the slider until the 90-180° triangle mark is aligned with the triangle mark on the hook.
3. Rotate the slider handle to adjust the X-Tune steering mechanism to the locked position.
4. Operate the slider handle to continue bending the pipe until the "0" line on the slider is aligned with the required bending angle. (The two handles will not cross)
Freezer pipe bender use-precise pipe bending (corresponding to the target point after measuring the bending)
1.90° bend:
Mark the pipe fittings according to the required distance (X) from the target point (pipe end, bending point, etc.). The distance is the distance from the center of the corner to the target point.
Place the pipe in the pipe bender.
If the target point is on the left side of the mark, align the mark on the pipe with the "L" line on the hook.
If the target point is on the right side of the mark, align the mark on the pipe with the "R" line on the hook.
After aligning the marks on the pipe fittings, move the hook so that the "0" line is aligned with the 90 degree line on the forming plate.
2.45° bend:
Mark the pipe fittings according to the required distance (X) from the target point (pipe end, bending point, etc.). The distance is the distance from the center of the arc to the target point.
Place the pipe in the pipe bender.
Align the mark on the pipe with the 45° line on the slider
After aligning the marks on the pipe fittings, move the hook so that the "0" line is aligned with the 45 degree line on the dial.
The above is an introduction to the use of the freezer pipe bender. I believe that everyone has a certain understanding of the relevant knowledge of the use of the freezer pipe bender through reading the above. When we are decorating, if you need to use the freezer pipe bender in front of the screen, you may wish to refer to the suggestions of the editor to use the freezer pipe bender. Hope the introduction of the editor will be helpful to you.
